* Boeing seen launching latest version of workhorse jet in June
* Engineers identify two-part solution for crucial gear design
* Boeing says no decision taken, discussion of launch premature
* Design decision has direct bearing on battle for jet sales


Boeing is nearing a decision to launch a larger version of its 737 workhorse jet within two months to counter strong sales of the Airbus A321neo, after a breakthrough on the design for one of its parts, industry sources said.
The 737 MAX 10 would narrow the gap between the 178-220 seat 737-9, which first flew this month, and the 185-240 seat A321neo, which dominates the top end of a market for narrowbody jets worth $2tn over 20 years.
Boeing has been studying how to solve a tricky problem with the design of the plane's landing gear, without adding cost or delaying a 2020 target for first deliveries.
The sources said a solution had been found and that Boeing was talking more deliberately to airlines about launching the 737-10 at the Paris Airshow in June. Boeing is said to anticipate a total market of 1,000 of the planes.
"Boeing is actively engaged in discussions with customers about the 737 MAX 10X," a spokesman said. "No decision has been made on the airplane and any discussion on timing of a possible launch would be speculative."
Boeing shares were up slightly in early trading.
Reuters reported last year that the 737-10 marks a tactical response to the A321neo, while Boeing works on strategic plans for a 220-260-seat twin-aisle, mid-market jet.
But it has produced a puzzle so tricky that Boeing has asked for help from its combat jet experts to design a space-saving gear for the 737-10.
A solution is needed because the 737-10 will be longer than the 737-9 to make room for about 12 extra seats. The landing gear must become taller too or the tail could scrape the runway.
Anxious to avoid costly changes to the rest of the plane and stay on schedule, Boeing aims to make the gear longer only when needed, but small enough to fit in the 737's existing wheel bay.
It has not made final decisions but is testing an advanced proposal to allow the 737 to effectively sit back on its heels as it leaves the runway.
This is what aerospace engineers call a "semi-levered" design and is a nod to two bigger jets: the 777 and 787-10.
In a further twist, the gear would lengthen telescopically for the 737-10 to charge down the runway. Afterwards, it would shrink again to retract into the same space.
Competition impact
Drawing-board decisions like these feed directly into the battle for jet sales.
A longer gear allows pilots to use the same take-off angle rather than easing off to avoid striking the runway with the tail of the longer jet. Shallower take-offs need more runway, limiting the number of airports served and restricting sales.
Airbus, which declined comment, will try to persuade potential 737-10 buyers that it is little different from the slow-selling 737-9. It is meanwhile said to be working on its own improvements to the A320 family codenamed A320neo-plus.
Market sources say Boeing is offering 5% lower costs per seat than the A321neo for the 737-10. Some experts are more cautious on operating costs, leaving jetmakers to slug it out over two other important drivers: range and performance.
Boeing decided against using a bigger engine to boost those features and is gambling that some airlines will prefer extra seats and fly the 737-10 mainly on short routes.
Although reports have focused on the clash between the A321neo and 737-9/10, industry sources say it's not just the top end of the narrowbody market that drives the new design.
Because most carriers stick to one jet family, they say Boeing seems worried the A321neo's success could prompt fleet decisions that weaken the smaller 737 MAX 8. The 737-10 would thus be an extra rampart to defend Boeing's biggest cash cow.
"It's a defensive move. Boeing wants to prevent the A321neo being a Trojan Horse in its own fleet," one strategist said.